![]() Put the radiator cap and reservoir cap back on and tighten firmly. If there is any loss of coolant, add coolant to the radiator’s filler neck and to the reserve tank’s “FULL” level.ġ0. Stop the engine and wait until the coolant cools down (122 to 1408F ). Start and race the engine at 2,000 to 3,000 rpm for 5 to 6 times within 40 seconds.ĩ. At this time, make sure that the rubber gasket in the radiator cap is correctly in place.Ĩ. Other than the connection between the pipe and the. It connects to the top of the left head, crosses over to the right where it connects to the right head, and then heads up and off to the right to connect with the upper radiator hose. The same steps may apply to other Subaru models and generations. The coolant crossover pipe ('water pipe') is located underneath the manifold. Put the radiator cap back on and tighten firmly. 100 subscribers Subscribe 201 28K views 1 year ago This is how to change the coolant on 2012-2016 Subaru Impreza. Pour the coolant and fill to the reservoir tank’s “FULL” level mark.ħ. The alcohol contained in the engine coolant may damage the paint surface.Ħ. Do not splash the engine coolant over painted parts.If engine coolant gets on the exhaust pipe, be sure to wipe it off. 2015 Subaru Forester Engine and Cooling Parts Change Category Assemblies (91) AIR CLEANER & ELEMENT. If coolant touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. Be careful not to spill engine coolant when adding it.Do not pour the coolant too quickly, as this may lead to insufficient air bleeding and trapped air in the system.įor the guidelines of coolant quantity (including coolant in the reservoir tank), refer to “Engine coolant”. Add genuine SUBARU cooling system conditioner until the coolant level reaches the filler neck. Slowly pour the coolant and fill up to just below the filler neck, allowing enough room to add genuine SUBARU cooling system conditioner in the radiator. To add coolant, remove the cap (with tabs) on the coolant tank on top of the engine.ĥ. The cap (without tabs) on top of the radiator does not need to be removed. Then drain the coolant from the reserve tank. Loosen the radiator cap to drain the coolant from the radiator. Place a proper container under the drain plug and loosen the drain plug.ģ. Since the coolant is under pressure, you may suffer serious burns from a spray of boiling hot coolant when the cap is removed.Īlways add genuine SUBARU coolant and genuine SUBARU cooling system conditioner whenever the coolant is replaced.Ĭhange the engine coolant and add genuine SUBARU cooling system conditioner using the following procedures according to the maintenance schedule.Ģ. Never attempt to remove the radiator cap until the engine has been shut off and has cooled down completely.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |